Load cells and sensors
A weighbridge depends on sensors that convert mechanical load into an electrical signal. WEIGHTEC SYSTEMS diagnoses and replaces weighbridge sensors and load cells precisely.
An inaccurate weighbridge is usually caused by one faulty sensor, a damaged cable or moisture. The diagnosis isolates the exact source before anything is changed.
WEIGHTEC SYSTEMS keeps the reusable mechanics, modernizes the control/electronics, and at project end the programs, backups and documents are handed over to the client. For sensors, the same principle applies: change only what is faulty.
After a correct diagnosis and replacement, the platform returns to balanced, stable measurement. The goal is a weighing chain that behaves predictably in daily use.
Usually a single faulty load cell can be replaced, provided it is matched to the others. WEIGHTEC SYSTEMS only changes what is necessary.
By measuring each cell's signal and comparing the values, then checking cables and connections. The diagnosis identifies the exact faulty component.
Yes. Every sensor replacement is followed by recalibration so the whole scale reads accurately.
Describe your installation and the symptoms you observe: WEIGHTEC SYSTEMS will guide you toward a suitable solution, without unnecessarily replacing your equipment.